Settings; Getting Information - Barco Coronis 3MP Installation & User Manual

Settings

To change the settings:
1 Turn the control wheel to select the setting you wish to change.
2 Click the control wheel to change the setting.
The Settings menu contains the following items:
DPMS ................... Allows to switch on/off the automatic power saving
Power LED ........... This setting allows you to switch off the power
User controls ........ This function allows you to disable the control

Getting information

The Information menu allows you to get a lot of information about the
display and the connected signals.
Proceed as follows:
1 In the main menu, turn the control wheel to select Information.
2 Click the control wheel to enter the information menu.
The Information menu contains the following items:
Product: ................... The display type
Serial No: ................ Indicates the display serial number
SW version: ............ Displays the current internal software version
Display Lifetime: ..... Indicates the total time the display has been
Backlight Lifetime: ... Indicates the total time the display has been
System manual Coronis 3MP
system (DPMS)
LED. Note: The LED's orange DPMS state is not
influenced by this setting. So, when the display
goes into power-saving mode, the LED will turn
orange, even if it was switched off by this setting.
wheel functions so that the on-screen display
cannot be used after quitting the OSD menus.
To enable the control wheel functions again:
a) Do not use the wheel for at least 3 seconds
b) Turn the control wheel 1 click clockwise
c) Click the control wheel 2 times
d) Turn the control wheel 1 click counterclockwise
e) Select the Settings menu and switch Local
controls on again.
Actions b, c, d have to be performed in a
sequence that takes no longer than 3 seconds.
operating, including the time in stand-by
operating, excluding the time in stand-by
Display installation
33