Automated Display Configuration; Reinstalling Drivers - Barco Coronis 5MP Installation & User Manual

Installing the B
ARCO
8. Follow the wizard's on-screen instructions to complete the
driver installation.
Note: The driver installation may take up to 5 minutes, and the
monitor may blink a few times during the installation process.
Note: For "non-English" operating systems, you may encounter
multiple pop-up screens. If this occurs, click the appropriate
buttons to complete the installation.
9. When the driver setup is complete, click the Finish button.
10. When the Setup complete message appears, select Reboot
System Now and click Finish.
11. After the system reboots, Windows may display either the
Digital Signature Not Found message or The software you
are installing for this hardware has not passed Windows
logo testing.

Automated display configuration

Once the drivers, software and documentation have been
installed and your system has been rebooted, the Barco Monitor
Plug and Play Software should automatically detect your Barco
displays and attach them to the desktop with the correct
resolution. If the Barco Monitor Plug and Play Software fails to
detect your Barco displays or fails to attach them to the desktop
correctly please refer to the section, Setting the resolution of
your Barco Display in the Configuring Windows section of this
manual.

Reinstalling drivers

You can install new drivers or reinstall existing drivers at any
time by using the Barco Set-up wizard on your B
Display System Installation CD-ROM, see Installing the B
MXRT drivers and software on page 46 of this manual.
48
MXRT drivers and software
C 5MP
ARCO ORONIS
ARCO