Barco Coronis 5MP Installation & User Manual page 27

IO-Panel for the BarcoMed Coronis, BarcoMed Nio, and
BarcoMed 5MP2FH family of display controllers
Head 1 – DVI-D Connection
Head 2 – DVI-D Connection
11. Reconnect any cables you have disconnected and plug in the
computer's power cord.
12. Turn on the display(s) and then your computer.
Turning on your system
WARNING: Wear a grounded, protective ESD strap when handling
or during installation of the display controller. Electrostatic
charges can damage the display controller.
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is
finished.
Note: Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and refresh
rates, such as 1536x2048@60Hz, are not available at this stage of
the installation. Once you have installed the B
Display System drivers and software, the Barco monitor Plug and
Play software should automatically set the resolution for the
displays.
13. Install the drivers, QAWeb software and documentation for
your B
ARCO
Figure 10
C 5MP Display System by following the
ORONIS
Installation Procedure
C 5MP
ARCO ORONIS
27