Table of Contents
Advertisement
¬ When the SCSI device parameters are wrong ¬
O Change the parameters.
To change a parameter, press the [:] or [;] arrow key to highlight the
item to be changed.
Next, press the [Enter] key.
selectable settings are displayed.
Highlight the item to be selected, and press the [Enter] key to make the
selection.
(2) Checking the SCSI IDs
1. Press the [:] or [;] arrow key to highlight the SCSI channel to be
checked, and press the [Enter] key to make the selection.
(Press the [Esc] key to return to the previous menu.)
2. The selection screen shown below now appears. Press the [:] or [;]
arrow key to highlight the [SCSI Disk Utilities] item, and press the [Enter]
key.
(Press the [Esc] key to return to the previous menu.)
Configure/View Host Adapter Settings
3. Check that the screen shown below now appears.
(Press the [Esc] key to return to the previous menu.)
Select SCSI Disk and press <Enter>
SCSI ID #0 :
No Device
SCSI ID #1 :
IBM
SCSI ID #2 :
IBM
SCSI ID #3 :
No device
SCSI ID #4 :
No device
SCSI ID #5 :
No device
SCSI ID #6 :
No device
SCSI ID #7 :
Adaptec SCSI Card 39160
SCSI ID #8 :
No device
SCSI ID #9 :
No device
SCSI ID #10 : No device
SCSI ID #11 : No device
SCSI ID #12 : No device
SCSI ID #13 : No device
SCSI ID #14 : No device
SCSI ID #15 : No device
¬ When there are not enough devices ¬
O Check that the power supply has been connected to the SCSI HDD.
O Check that the SCSI cable has been connected properly.
O Check the SCSI ID settings.
– 41 –
A pop-up menu will appear, and the
Options
SCSI Disk Utilities
DDYS-T18350M
DDYS-T18350M
The figure on the left
shows the information for
channel A.
With channel B, IBM
DDYS-T18350M is
displayed for #0 as well.
Advertisement
Chapters
Table of Contents
