Registering A Key Finder To The Unit - Panasonic KX-TGA20AZ Installation Manual

Registering a key finder to the unit

Important:
R For key finder supplied users: The supplied key finder has been
pre-registered to the unit.
R Do not install the battery until you activate the key finder registration using the
handset.
R After installing the battery in step 2, the registration mode will end within 30
seconds.
R Handsets have either symbol type handset keys or English type handset keys.
Operate the handset by using the keys on your handset.
1
Handset:
For key finder 1: M
For key finder 2: M
For key finder 3: M
For key finder 4: M
*1
2
Key finder:
With the tab pushed to the right (A), pull out the battery holder (B). Insert the
battery with (
R Confirm that the battery is set correctly (
R The key finder will go into the registration mode automatically and the
3
Wait until a long beep sounds.
R After the key finder is registered, the finder number is displayed.
4
Handset: MeN or MOFFN
If the registration tones do not sound or the registration fails, you need to remove
the battery from the key finder once to make the key finder available for
registration again. Leave the battery out of the key finder for over 2 minutes,
and then repeat from step 1.
TGA20EX_FX_AZ(en)_0206_ver103.pd3
N (right soft key) or MMENUN a #6571
N (right soft key) or MMENUN a #6572
N (right soft key) or MMENUN a #6573
N (right soft key) or MMENUN a #6574
If you have 2 or more key finders.
) facing up (C), then close the battery holder (D).
registration tones will sound.
B
A
3
Installation
*1
*1
*1
, ).
C
D
2013/02/06 16:38:01
3