14. The uploaded data can be played by inputting the space key after the clip
registered in the bin has been clicked (selected).
15. Check the clip's playback images on the monitor (video) for monitoring
16. Playback automatically stops at the end of the selected clips.
To stop playback at any time, input the space key again.
) Were the clips registered in the bin selected when they were clicked?
) Was the selected clip played (at a1 speed) when the space key was
) Did the selected clip stop playing when the space key was pressed
) Was the playback AV of the selected clip affected by noise or
All the playback images of the clips are checked on the monitor (video) for
monitoring the pictures.
This now completes the check for the uploading operation and the uploaded
data for the internal VTR's 50M a2 speed mode.
To conduct further checks on the uploading for
O Internal VTR (50Mx1): Internal VTR 50M a1 speed,
O Internal VTR (25Mx4): Internal VTR 25M a4 speed and
O Internal VTR (25Mx1): Internal VTR 25M a1 speed,
select "Internal VTR (50Mx1)", "Internal VTR (25Mx4)" and "Internal VTR
(25Mx1)" as the device displayed on the VTR control panel, and conduct the
same checks described above as for "Internal VTR (50Mx2)."
Even with a system that connects an external VTR or a system which uses a
microphone for uploading, select the name of a device displayed from among
those listed below, and conduct the same checks as the ones conducted so
far. The table below shows the settings for the input/output signals, data
format during uploading and RS-422 port in the limited edition of the editing
Connect the signal lines and conduct the checks in accordance with these
Name of device
External VTR 1
External VTR 2
External VTR 3
Mic input jack
front panel used
– 22 –
Data format during