Reporting To Private Telephone - Visonic PowerMax User Manual

SPECIAL FUNCTIONS
B. Executable Commands
Command
Disarming
Arming Home
Arming Home-Instant
Arming Away
Arming Away-Instant
Arming Away-Latchkey
Arming Away-Instant-
Latchkey
Elect. Devices (No. 01-
15) ON
Elect. Devices (No. 01-
15) OFF
Activating PGM output
Deactivating PGM output [ ] [5] [0]
Two-way voice
communication
(see sub-par. C)
Recorded message
playback
Recorded message start
record
Recorded message stop
record
Recorded message
erase message
Investigating system
status
Quit (end
communication)
C. Two-Way Voice Communication
(Not to be used in UL-listed systems)
Perform steps 1-6
Communication above and continue as follows:
1. [ ] [7] [ #]
2. Wait for 2 beeps
3. [3] or [1] or [6] (see below)
The system will start to function in the "LISTEN IN"
mode, letting you hear the sounds within your
residence for 50 seconds. If the person under
surveillance happens to speak or cry then, you will
hear this. You can switch the system to Listen-In,
Speak Out or Full Duplex, as shown in the next
table.
20
Keying Sequence
[ ] [1] [#]
[ ] [2] [#]
[ ] [2] [ 1] [#]
[ ] [3] [#]
[ ] [3] [1] [#]
[ ] [4] [#]
[ ] [4] [ 1] [#]
[ ] [5] [device No.] [1]
[ ] [5] [device No.] [0]
[ ] [5] [0] [0] [1] [#]
[0] [0] [#]
[ ] [7] [ #]
[ ] [8] [ 1 ] [#]
[ ] [8] [ 2 ] [#]
[ ] [8] [ 3 ] [#]
[ ] [8] [ 4 ] [#]
[ ] [9] [#]
[ ] [9] [9] [#]
in Establishing Telephone
Command
Listen-in (listening to the person at home) (*)
Speak-out (speaking to the person at home)
(*)
Full-duplex (listening & speaking) (*)
Note: To prolong the communication session
by 50 seconds, press [3], [1] or [6] again, as
required.
* The 2-way communication can be terminated by
anyone close to the PowerMax+, by disarming
the system.
Remark Regarding Listen-in & Speak-out modes
[ #]
Listen-in & Speak-out modes allow one way speech at
a time. Back and forth exchange of uninterrupted
[ #]
speech between two parties is a method normally
used in military, commercial and amateur radio
communication. Once you finish talking you should
say "Go Ahead" or "Over" and then switch from speak-
out to listen in. When the person at home finishes
talking he should also say "Over", as a cue to you to
switch back from Listen-in to speak out.
EXAMPLE:
You (at remote telephone):
can you hear me? Are you in any trouble? Over"....
[3]
Person at home: "Yes, I am. I had a dizzy spell while
trying to get out of bed and fell on the floor. I am
unable to get up and my thigh hurts. Can you help
me? Over"...
You (at remote telephone):
send someone right away, stay put - over"..
Person at home: "Thanks, please hurry, over".
You (at remote telephone):
and out".....
Important! If you
communication
command, just press [ ] and then key your user
code followed by the command (see "keying
sequences" in Executable Commands table above).

Reporting to Private Telephone

PowerMax+
control
panel
The PowerMax+ can be programmed by the installer
for selective transmission of messages to private
telephone subscribers. Messages are divided by type
into 3 groups:
Group Events Reported
1 Fire, Burglary, Panic, Tamper
2 Arming AWAY, Arming HOME, Disarming
3 No-activity, Emergency, Latchkey
[1], "Hey, George,
[1], "Sure, I will
[1], "All right, over
[ ] 9] [9] (END OF SESSION)
wish to exit the
mode and execute
Key
[3]
[1]
[6]
[3].
two-way
another
DE5467U