Removing I/O Boards - AMX Optima Instruction Manual

Appendix D – Adding or Replacing I/O Boards

Removing I/O Boards

To remove an Optima I/O board (or blank board plate):
1a: Remove the five screws indicated (four from the top and one from the side).
1
1b: Remove the rack ear indicated (four screws).
FIG. 89
Remove 5 screws and rack ear (4 screws)
Note: If the screw circled in red in Step 1 is silver or if a silver screw was shipped with the new
board(s), be sure to screw it into the same hole in Step 6 of the "Adding I/O Boards" procedure on
page 153.
2a: Remove the three screws indicated from the bottom of the enclosure.
2
2b: Remove the expansion plate (two screws).
2a
FIG. 90
Remove 3 screws and expansion plate (2 screws)
148
Stand the enclosure on this side for Steps 2 and 3.
1a
Screw will be in one of these 2 holes
Important: See Note below this
step regarding this screw.
1a
Expansion plate
2b
Screw will be in one of these 2 holes
1b
Optima Instruction Manual