AMX Optima Instruction Manual page 122

APWeb Expansion Board

~scrv3i3!
[3:Communication Interfaces] count = 3
[interface 1] detected
[type] BCS mode RS232 port, 57600 (8/1/N/E/NS)
[interface 2] detected
[type] MCF5272 FEC Ethernet Controller
[interface 3] detected
[type] Neuron bridge v1.0.3
If APWeb opens, but the Home page displays a message that says, "There is no VM
configuration information available":




116
Enter the diagnostic command ~scrv3i3!
Verify that one of the [type] lines displays the following configuration:
BCS mode RS232 port, 57600 (8/1/N/E/NS)
or
BCS mode RS232 port, 57600 (8/1/N/NE/NS)
Log on APWeb using the Network Administrator's user name and password (found in the
Instruction Manual – APWeb Interface).
Click the Configuration link. Check to be sure that Force VM Discovery is turned on.
If Force VM Discovery is not on, check it on and click the Reboot button.
If the problem persists, contact technical support (see page 40).
Interface configuration
Optima Instruction Manual