AMX Optima Instruction Manual page 156

Appendix D – Adding or Replacing I/O Boards
5 Remove the two center slide-keys.
FIG. 93
Remove center slide-keys (2)
6a: Remove the screw(s) indicated.
6
6b: Remove the board(s) or the blank board plate(s).
6b
FIG. 94
Remove screw(s) and board or blank board plate
Important: Be sure to install the new board(s) in the correct slot (see the "AutoPatch Connector
Guide"). The board's location must match the system's configuration information. If a board is
installed in the wrong slot, signal routing is affected.
150
Position with gold card edges at top
Spacers
Spacers not connected to boards fall free when slide-keys are removed
Center slide-keys
If removing a board, place the board in an ESD approved static shield bag and set aside.
6a Double-connector boards require removal of 2 screws
Optima Instruction Manual