Asynchronous Port - Allied Telesis AR410 User Manual

Physical and Layer 2 Interfaces
Software Release 2.7.1
C613-02021-00 REV F

Asynchronous Port

Asynchronous ports are normally used to connect a terminal to the router for
configuration purposes. The default values for configurable parameters are
modified by entering the command:
SET ASYN=port-number option
The factory default settings for asynchronous ports are shown in Table 8 on
page 75.
Table 8: Factory defaults for configurable parameters for asynchronous ports.
Option
ATTENTION
CDCONTROL
DATABITS
DEFAULTSERVICE
DTRCONTROL
ECHO
FLOW
HISTORY
INFLOW
IPADDRESS
IPXNETWORK
MAXOQLEN
MTU
NAME
OUTFLOW
PAGE
PARITY
PROMPT
SECURE
SERVICE
SPEED
STOPBITS
TYPE
For more information about asynchronous ports, see the Hardware Reference
or the Interfaces chapter in the Software Reference.
For more information about configuring PPP interfaces across an asynchronous
interfaces, see the Point to Point Protocol (PPP) chapter in the Software
Reference.
Default setting
BREAK
IGNORE
8
FALSE
ON
ON
HARDWARE
30
HARDWARE
NONE
NONE
0 (Unrestricted)
1500
Asyn #
HARDWARE
22
NONE
DEFAULT (CMD>)
ON
NONE
AUTO
1
VT100
75