Saving The Router's Configuration - Allied Telesis AR410 User Manual

58
The commands you enter into the router from the command line affect only the
dynamic configuration in RAM, which is not retained over a power cycle. The
router does not automatically store these changes in FLASH memory. When
the router is restarted, it loads the configuration defined by the boot script, or if
the router was restarted using the RESTART command, any script file specified
in the RESTART command.
In addition to the boot configuration script that the router automatically runs
when it restarts, you can run a configuration script manually at any time, by
entering the command:
ACTIVATE SCRIPT=filename
You can also set a trigger to automatically execute a configuration script when
a specified event occurs.
For more information about how to create and run scripts, see the Scripting
chapter in the Software Reference.
For information about creating triggers, see the Trigger Facility chapter in the
Software Reference.

Saving the Router's Configuration

To view the router's current dynamic configuration, enter the command:
SHOW CONFIGURATION DYNAMIC
To save any changes made to the dynamic configuration after the router last
restarted (booted) across a restart or power cycle, and save the modified
configuration as a script file, enter the command:
CREATE CONFIG=filename.scp
To set the router to execute this script file when it restarts, enter the command:
SET CONFIG=filename.scp
The configuration file created by CREATE CONFIG command records passwords in
encrypted form, not in cleartext.
You can create a script file from any of the router software commands. These
are the same commands that are used to change the router's configuration
dynamically. Manually edit a configuration file using the router's built in
editor (see "Using the Built-in Editor" on page 67), or upload it to a PC using the
UPLOAD command (see the Operation chapter in the Software Reference), edit
it using any text editor, and download it again. Give configuration script files
an extension of or
.scp
To display the name of the configuration file that is set to execute when the
router restarts, enter the command:
SHOW CONFIG=filename
.
.cfg
AR400 Series Router User Guide
Software Release 2.7.1
C613-02021-00 REV F