Allied Telesis AR410 User Manual page 101

Routing
Software Release 2.7.1
C613-02021-00 REV F
To configure IP follow these steps
The following steps are required:
1. Configure the PPP Link.
2. Create a VLAN and add untagged ports.
3. Configure the IP routing module on both routers.
4. Test the configuration.
5. Save the configuration.
1. Configure the PPP Link
Refer to other sections of this guide on how to configure PPP interface 0 on
each router to use the wide area link.
• See "Point to Point Protocol (PPP)" on page 81 for information about
configuring PPP to use a synchronous link.
• See "Configuring ISDN (models with PIC bay)" on page 87 for information
about configuring PPP to use an ISDN call.
• If the PPP interface is configured for dial-on-demand operation
(see"Configuring ISDN Dial on Demand" on page 92) or bandwidth on
demand operation (see "Configuring ISDN Bandwidth on Demand" on
page 93), these services are automatically used by the IP routing
software.
2. Create VLANs and add untagged ports
Each new VLAN is created with a VLAN name that is unique in the router,
and a VLAN Identifier (VID) that uniquely identifies the VLAN on the
physical LAN. If the VLAN name begins with "vlan" and ends in a
number then the number must be the same as the VID specified. To create
VLANs, enter the command:
CREATE VLAN=vlanname VID=2..4094
In this example two VLANs are created by entering the commands:
CREATE VLAN=vlan2 VID=2
CREATE VLAN=vlan3 VID=3
To add untagged ports to vlan2, enter the command:
ADD VLAN=vlan2 PORT=2-4
To add untagged ports to vlan3, enter the command:
ADD VLAN=vlan3 PORT=1-3
See the Switching on the AR410 or Switching on the AR440S, AR441S and
AR450S chapter in the Software Reference for more detailed information
about creating VLANs and VLAN ports.
101