Allied Telesis AR410 User Manual page 107

Routing
Software Release 2.7.1
C613-02021-00 REV F
3. Configure IP.
To enable IP on the router, and assign IP addresses to the interfaces used by
DVMRP for multicast routing, enter the commands:
ENABLE IP
ADD IP INTERFACE=PPP0 IPADDRESS=189.124.7.8
MASK=255.255.0.0
ADD IP INTERFACE=ETH0 IPADDRESS=172.74.1.2
MASK=255.255.255.0
ADD IP INTERFACE=ETH1 IPADDRESS=172.74.2.2
MASK=255.255.255.0
4. Configure IGMP.
To enable IGMP on the router, and on the interfaces that have IP host
connected to them, so that the router can maintain its group membership
data, enter the commands:
ENABLE IP IGMP
ENABLE IP IGMP INTERFACE=PPP0
ENABLE IP IGMP INTERFACE=ETH0
ENABLE IP IGMP INTERFACE=ETH0
5. Configure DVMRP
To enable DVMRP on the router and on each interface over which it is used
for multicast routing, enter the commands:
ENABLE DVMRP
ADD DVMRP INTERFACE=ETH0 METRIC=1
ADD DVMRP INTERFACE=ETH1 METRIC=1
ADD DVMRP INTERFACE=PPP0 METRIC=6
Configure multicast routing using DVMRP on Router C.
1. Set the system name.
To set a unique system name for the router, enter the command:
SET SYS NAME=C-dvmrp
2. Configure Frame Relay.
To configure a Frame Relay interface over a synchronous port to Router D,
and add a data link circuit to the Frame Relay interface, enter the
commands:
CREATE FRAMERELAY=0 OVER=SYN0 LMISCHEME=NONE
ADD FRAMERELAY=0 DLC=20
3. Configure ISDN.
Set up an ISDN call to Router A for DVMRP multicast traffic. This call
must have the same name as the ISDN call from Router A, and the opposite
precedence. Enter the command:
ADD ISDN CALL=DVMRP OUTSUB=LOCAL SEARCHSUB=LOCAL
PRECEDENCE=IN NUM=7654321
107