Before You Start; Configuring Ip - Allied Telesis AR410 User Manual

100
Figure 14: Example configuration for an IP network.
Head Office Router
172.16.8.0
Table 11: Example configuration parameters for an IP network .
Parameter
VLAN interface
Ports (untagged)
VLAN interface IP address
VLAN IP subnet address
Ethernet LAN IP subnet mask
PPP interface
PPP interface IP address
PPP interface IP subnet address
PPP interface IP subnet mask

Before You Start

1. Ensure that the routers you want to configure are connected as described in
the Quick Install Guide.
2. Connect a terminal to the console port (port 0) on each router as described
in the Quick Install Guide. Alternatively, you can connect a PC to the console
port and use a terminal emulation program like Windows™ Terminal.
3. Login to the MANAGER account on each router (see "Logging In" on
page 15).

Configuring IP

This example (Figure 14 on page 100) illustrates the steps required to configure
TCP/IP using the router's command line interface. Two routers running TCP/
IP will be connected together using the Point-to-Point Protocol (PPP) over a
wide area link. Each router is associated with a VLAN.
172.16.254.1
PPP Data Link
172.16.8.33
Head Office Router
vlan2
Ports 2-4
172.16.8.33
172.16.8.0
255.255.255.0
ppp0
172.16.254.1
172.16.254.0
255.255.255.0
AR400 Series Router User Guide
Remote Office Router
172.16.254.2
192.168.31.30
Remote Office Router
vlan3
Ports 1-3
192.168.31.30
192.168.31.16
255.255.255.240
ppp0
172.16.254.2
172.16.254.1
255.255.255.0
192.168.31.16
UGIP1_R
Software Release 2.7.1
C613-02021-00 REV F