Enabling Special Feature Licences; Setting System Parameters - Allied Telesis AR410 User Manual

Also, typing a question mark "?" at the end of a partially completed command
displays a list of the parameters that may follow the current command line,
with the minimum abbreviations in uppercase letters. The current command
line is then re-displayed, ready for further input.

Enabling Special Feature Licences

You must enable the special feature licence you have purchased before you can
use the licenced features. You will need the password provided by your
authorised distributor or reseller. The advanced upgrade licence and password
are different from the standard software release licence and password. The
licence cannot be transferred from one router to another.
For software features that require a special feature licence see "Special Feature
Licences" on page 12.
You must order passwords for special feature licences from your authorised distributor
or reseller. You must specify the special feature licence bundle and the serial number(s)
of the router(s) on which the special feature licences are to be enabled.
The password for a special feature licence is a string of at least 16 hexadecimal
characters. This password encodes the special feature, or features, covered by
the license, and the router serial number. The password information is stored in
the router's FLASH memory.
To enable or disable a special feature licence, enter the commands:
ENABLE FEATURE=feature PASSWORD=password
DISABLE FEATURE=feature
To list the current special feature licences, enter the command:
SHOW FEATURE[={featurename|index}]

Setting System Parameters

You can set some general system parameters to ensure the router's
compatibility with the public network, and to aid network administration.
Some services, for instance ISDN, use slightly different versions in different
countries. To make sure that the router uses protocols consistent with the
services it is connected to, set the system territory to the country or region in
which your router operates. Enter the command:
SET SYSTEM TERRITORY={AUSTRALIA|CHINA|EUROPE|JAPAN|KOREA|
NEWZEALAND|USA}
In Australia only: to use the Micro service, SET SYSTEM LOCATION=australia; to
use the OnRamp service, SET SYSTEM LOCATION=europe.