Table of Contents
Advertisement
Hardware Installation
This section will assist you in quickly installing your system hardware. Wear a wrist
ground strap before handling components. Electrostatic discharge may damage the
system's components.
CPU Processor Installation
This mainboard supports Intel
your system, we suggest you visit the Intel website and review the processor installation
procedures.
http://www.intel.com
CPU Socket 775 Configuration Steps:
1. Locate the CPU socket 775 on your
mainboard and nudge the lever away
from the socket as shown. Then lift
the lever to a 140-degree angle (A).
Next, lift up the iron cover (B).
2.
There
are
2
distinctive
located near the corners of the socket
on the same side as the lever as shown
(C). Match these marks with the marks
on the CPU and carefully lower the
CPU down onto the socket (D).
3. Replace the iron cover and then
lower the lever until it snaps back into
position (E). This will lock down the
CPU (F).
4. Smear thermal grease on the top of the CPU. Lower the
CPU fan onto the CPU/CPU socket and secure it using the
attachments or screws provided on the fan. Finally, attach
the fan power cable to the CPUFAN adapter.
Attention: DO NOT touch the pins on the socket (the pins are sensitive and
can be easily damaged). Also, make sure that you have completed all of the
installation steps before starting the system. Finally, double-check that the
heatsink is properly installed and make sure that the CPU fan power cable is
securely attached (cooling problems can cause overheating, leading to
damage to the CPU and other sensitive components).
PX915P/ PX915G Series
Pentium
4 processors using a Socket 775. Before building
®
®
A
marks
C
E
9
B
D
F
Advertisement
Table of Contents
