Table of Contents
Advertisement
Hardware Installation
This section will assist you in quickly installing your system hardware. Wear a wrist ground strap
before handling components. Electrostatic discharge may damage your system components.
CPU Processor Installation
This mainboard supports Intel
system, we suggest you visit the Intel website and review the processor installation procedures.
http://www.intel.com
CPU Socket 478 Configuration Steps:
1.
Locate the CPU socket on your mainboard and nudge the lever away from the socket. Then lift
the lever to a 90-degree angle.
2.
On the socket, locate the corner that has the pin-1 receptor. This corner will be near the end of
the lever on the socket. Match the dot on the CPU with the pin-1 receptor on the socket and
lower the CPU onto the socket. The bottom of the CPU should be flush with the face of the
socket.
3.
Lower the lever until it snaps back into position. This will lock down the CPU.
4.
Smear t
hermal grease on top of the CPU. Lower the CPU fan onto the CPU and
on the fan to attach it to the socket. Finally, extend the power cable from the fan and insert It
onto the CPUFAN adapter.
®
®
Pentium
4 processors using a Socket 478. Before building your
Pin1 Receptor
Attention: Before starting the system
Please check the installation completely before starting the system.
Verify that the heatsink is properly installed and make sure the CPU
fan is working. Overheating can damage the CPU and other
sensitive components.
7
PX865PEL-800
Dot
use the clasps
Advertisement
Table of Contents
