•
EXT CTL FILE
Creates a new file during a record session without losing
frames.
TIME CODE EXT, REC RUN, FREE RUN, REGEN
The following are timecode (
•
TC EXT
Group Default
Records the incoming source timecode. If the timecode is not
running, the FS100 records the same timecode number in
each recorded frame. Choose
stored number.
•
TC REC RUN
In this mode, after a power cycle, the FS100 starts its TC record
count using the
recorded. A power cycle resets the TC record value to the
value.
•
TC FREE RUN
This function causes the FS100 to begin counting from the
value stored by
•
A number entered through
to the FS100 until exiting
begin counting using that number.
•
TC REGEN
When the FS100 powers up in
•
Reads the timecode of the last track recorded.
•
Adds 1 to the number.
•
Stores the new timecode as the number that will be assigned to
the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings with, the
FS100 uses the
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
TC EXT Recommended for Pulldown Applications
If the recording signal contains pulldown information in 720/60p format, the
frame flag information contained is preserved in TC EXT mode and is
required for the editing process.
FS100 Portable DTE Recorder
) functions.
TC
TC EXT
TC SET
value. Later recordings add to the last value
.
TC SET
TC SET
. Only then does the FS100
TC SET
TC REGEN
value.
TC SET
FS100 Functions
mode to clear any
TC SET
is not stored and available
mode, it:
53