Time Code Ext, Rec Run, Free Run, Regen - Focus FS-C User Manual

FS-C Functions

TIME CODE EXT, REC RUN, FREE RUN, REGEN

The FS-C 2.0 upgrade provides additional
, and
RUN TC REGEN
This functionality is only active when HD FORMAT is set to
. In M2T mode, all TC modes act as
QUICKTIME
The following are timecode (
• TC EXT
Records the incoming source timecode. If the timecode
is not running, the FS-C records the same timecode
number in each recorded frame. Choose
clear any stored number.
• TC REC RUN
In this mode, after a power cycle, the FS-C starts its TC record
count using the
value recorded. A power cycle resets the TC record value to
the
TC SET
• TC FREE RUN
This function causes the FS-C to begin counting from
the value stored by
• A number entered through
available to the FS-C until exiting
the FS-C begin counting using that number.
• TC REGEN
When the FS-C powers up in
• Reads the timecode of the last track recorded.
• Adds 1 to the number.
• Stores the new timecode as the number that will be
assigned to the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings,
the FS-C uses the
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
70
functionality in HD RECORDER mode.
TC
Group Default
DV mode only
value. Later recordings add to the last
TC SET
value.
DV mode only
TC SET
DV mode only
TC SET
TC REC RUN
) functions.
.
is not stored and
TC SET
TC SET
TC REGEN
value.
FS-C Portable DTE Recorder
,
TC FREE
.
TC EXT
mode to
TC EXT
. Only then does
mode, it: