Page 2
1370 Dell Avenue Campbell, CA. 95008 www.focusinfo.com Monday through Friday 9:00 AM to 5:00PM techsupport@como.com +49 4307 - 83 58 58 +49 4307 - 83 58 99 COMO Computer & Motion GmbH A Focus Enhancements Company Lise-Meitner-Str.15 24223 Raisdorf / Germany www.focusinfo.com...
Page 3
Removable Pack Power Supply connector and power cord Missing or Damaged Components If there are missing or damaged items, contact Focus Enhancements Support for assistance; refer to the contact information at the front of this guide. FS-100 Portable DTE Recorder...
Quick Start Guide 2 Description Front Function buttons Power ON and Reset Record Button Back Search Back Index Power On Button The Power ON button provides two functions. Power ON Turn on the FS-100. Reset FS-100 • FS-100 first must be powered on. •...
Page 5
Remote Control (Serial Connector) Computer (FireWire Connector) Status LED Charge LED Bottom FS-100 Portable DTE Recorder Camera (FireWire Connector) Power Connector Cooling Vent Do Not Block Quick Start Guide Internal Speaker...
Warning: Do Not Use Unapproved Battery Chargers Use of battery chargers not approved by Focus Enhancements could cause the battery to catch fire or explode. 180-Minute Battery and Charger Available Focus Enhancements offers a high-capacity,180-minute battery and battery-charger.
Page 7
Quick Start Guide 4 Configure FS-100 Use the FS-100 Navigation buttons to locate and set the following parameters. Welcome Screen Home Screen FS-100 Portable DTE Recorder...
Quick Start Guide Set Date and Time This is a one time set up. Go to the SETUP arrow key. Right Select the date using the the and then Right Set date in the using the arrow keys. Press the BACK SETUP Select the time .
Page 9
5 Connect FS-100 to AG-HVX200 1394 connector Camera connector 6 Configure Camera and Record Power on the camera. Set the TAPE/P2 Press the MENU Select the RECORDING SETUP Set the REC FORMAT P2 (PN modes are not supported). Under the OTHER FUNCTIONS BOTH Press...
Page 10
Quick Start Guide 7 Playback Set the AG-HVX200 A thumbnail screen appears in the camera’s LCD. To turn off thumbnail display, press Use the FS-100 Transport 8 Create P2 Directories and Organize Files Perform this step only after recording is completed.
Page 11
9 Transfer Files from FS-100 to Computer Connect the FS-100 through its COMPUTER I/O 1394 port to the computer system using a standard 6-pin to 6- pin FireWire cable. Go to the HDD MODE menu. Select the DD DRIVE and use the Right Arrow to go to the screen.