Time Code Ext, Rec Run, Free Run, Regen - Focus FS-4 User Manual

FireStore Functions
TIME CODE EXT, REC RUN, FREE RUN,
REGEN
The following are timecode (
• TC EXT
Records the incoming source timecode. If the timecode is not
running, and the FS-4 records the same timecode number in
each recorded frame. Choose
stored number.
• TC REC RUN
This function creates a time code number for the first frame
of the next recording. To do this it can either:
•
FS-4
Take the last timecode recorded and add 1,
•
FS-4 Pro
Use the value stored in
The FS-4 stores the last recorded timecode in its non-volatile
memory, so it can persist across recording sessions.
• TC FREE RUN
This function causes the FS-4 Pro to begin counting from the
value stored by
• A number entered through
to the FS-4 until exiting
begin counting using that number.
• TC REGEN
When the FS-4 Pro powers up in
• Reads the timecode of the last track recorded.
• Adds 1 to the number.
• Stores the new timecode as the number that will be assigned to
the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings, the
FS-4 Pro uses the
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
60
TC
Group Default
FS-4 Pro only
.
TC SET
FS-4 Pro only
TC SET
) functions.
mode to clear any
TC EXT
.
TC SET
is not stored and available
TC SET
. Only then does the FS-4 Pro
TC SET
TC REGEN
value.
mode, it: