Time Code Ext, Rec Run, Free Run, Regen - Focus FS-100 User Manual

TIME CODE EXT, REC RUN, FREE RUN, REGEN

The following are timecode (
•
TC EXT
Group Default
Records the incoming source timecode. If the timecode is not
running, the FS-100 records the same timecode number in
each recorded frame. Choose
number.
•
TC REC RUN
In this mode, after a power cycle, the FS-100 starts its TC
record count using the
the last value recorded. A power cycle resets the TC record
value to the
•
TC FREE RUN
This function causes the FS-100 to begin counting from the
value stored by
A number entered through
available to the FS-100 until exiting
the FS-100 begin counting using that number.
•
TC REGEN
When the FS-100 powers up in
Reads the timecode of the last track recorded.
Adds 1 to the number.
Stores the new timecode as the number that will be
assigned to the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings with, the
FS-100 uses the
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
TC EXT Recommended for Pull-down Applications
If the recording signal contains pull-down information in 720/60p format,
the frame flag information contained is preserved in TC EXT mode and
is required for the editing process.
) functions.
TC
TC SET
value.
TC SET
.
TC SET
value.
TC SET
mode to clear any stored
TC EXT
value. Later recordings add to
is not stored and
TC SET
TC SET
mode, it:
TC REGEN
FS-100 Portable DTE Recorder
FS-100 Functions
. Only then does
61