Protection Threshold (1-28); Xcv Threshold; System Management; Figure 3-10.System Management Configuration Menu - ADTRAN MX2800 STS-1 System Manual

Section 3, Configuration

System Management

Protection Threshold (1-28)

The Protection Threshold setting determines how many of the Enabled lines must fail before a card switch
occurs. To cause the failure of a single protected (enabled) line to switch to protection, set the Protection
Threshold to 1. Choices are 1 to 28.

XCV Threshold

Set a limit on code violations (CVs) accepted by the unit over an individual T1/E1 line before it switches
controller cards. If set to Disabled, code violations do not cause the unit to switch controller cards. The
threshold limits are described in the following chart:
Setting The unit switches controller cards if...
-3
1E more than one out of every 1,000 bits received on a T1/E1 line contains a code violation
-4
1E more than one out of every 10,000 bits received on a T1/E1 line contains a code violation
-5
1E more than one out of every 100,000 bits received on a T1/E1 line contains a code violation
-6
1E more than one out of every 1,000,000 bits received on a T1/E1 line contains a code violation
3. SYSTEM MANAGEMENT
System management is possible through either SNMP, TL1, or VT-100 menus. Access is possible via craft
port, SLIP/PPP modem port, or 10Base-T ethernet interface. The menu
customize alarm and trap generation, security setup, and equipment identification. The availability of some
options in this menu vary depending upon the configuration of other options.
3-16
Figure 3-10. System Management Configuration Menu
MX2800 STS-1 User Manual
(Figure 3-10) includes options to
61204659L1-1A