Table of Contents
Advertisement
MX2800 STS-1 User Manual
The MX2800 STS-1 specifically uses "quoted line(s)" in REPT-ALM and REPT-EVT autonomous
messages. The REPT-ALM message has the following quoted line format:
<AID>:<NTFCNCDE>,<CONDTYPE>,<SRVEFF>,<OCRDAT>,<OCRTM>,<LOCN>...
The
field will contain one of the following values:
NTFCNCDE
• CL - Alarm Cleared
• TC - Transient Condition
• MN - Minor
• MJ - Major
• CR - Critical
The
message has the following quoted line format
REPT-EVT
<AID>:<CONDTYPE>,<CONDEFF>,<OCRDAT>,<OCRTM>,<LOCN>...
The CONDEFF field will contain one of the following values:
• CL - Standing Condition Cleared
• SC - Standing Condition Raised
• TC - Transient Condition
For possible CONDTYPE codes for both REPT-ALM and REPT-EVT quoted lines, refer to the condition
types listed in
Table 9-3
Refer to
TL1 Autonomous Messages
by the MX2800 STS-1.
4.
TL1 COMMANDS
As stated in
TL1 Messages
<verb>[-<mod1>[-<mod2>]]:<tid>:<aid>:<ctag>:<general block>:<keyword
block>: <state block>;
Areas of concentration for TL1 support in the MX2800 STS-1 include session initiation, termination, user
account management, and system event reporting.
MX2800 STS-1.
The Target ID (TID) is the same as the MX2800 Unit ID. (Refer to the
VT100 menus: Configuration/System Management/Equipment
Identification).
61204659L1-1A
on page 11 and
Table 9-4
on page 9-11 for a list of autonomous messages currently supported
on page 9-3, the general format for a TL1 command is:
Transaction Language 1 (TL1), Section 9
on page 14, respectively.
Table 9-2
lists the commands currently supported by the
NOTE
TL1 Commands
9-5
Advertisement
Table of Contents
