Error Messages; Operator Panel Error Messages - NEC SuperScript 1450 User Manual

The text is wrong, garbled, or incomplete.
Possible Cause
The operating system is If printing from Windows (any version), exit to
malfunctioning. a DOS prompt and verify functionality with
the following command:
• At a C:\ prompt, type Dir LPT1, then
press Enter. (This assumes you are
connected to LPT1.)
• Exit Windows and reboot the computer.
• Turn the printer off and then back on
again.
Pages print, but are totally blank.
Possible Cause
The toner cartridge is Replace the Toner Cartridge.
defective or out of toner.
The sealing tape may • Remove the Toner Cartridge and pull out
still be in the toner the sealing tape.
cartridge.
• Reinstall the toner cartridge, and check
the printer by printing a demo page.
The file may have blank Check the file to make sure that it does not
pages. contain blank pages.
Some parts, such as the Contact a service representative.
controller, the board,
may be defective.
Solution
Solution
E M
RROR ESSAGES

Operator Panel Error Messages

When the printer experiences an error, the Operator Panel
will indicate the error messages by the LEDs. Find the light
pattern below that matches the printer light pattern and
follow the solutions to clear the error.
Mode
Power Off
If none of the Operator Panel LEDs are lit,
• Check the power cord and the power switch if your
printer does not generate a response.
• Make sure that the printer is powered with the
specified AC voltage.
Paper Out
• The paper tray is empty and must be refilled with
paper. The Paper LED blinks until paper is added.
• Loading paper into the tray will cancel this message
and allow you to continue with the print job.
Message

Error Messages

77