NEC SuperScript 1450 User Manual page 81

Problem
Blank Areas If blank or faded areas appear randomly on
the page:
• The Toner Cartridge may be defective.
Remove the cartridge and check for
damage.
• Replace the Toner Cartridge if it is worn
or has reached the end of its expected
life.
Smeared Back If the back of the page is smeared with toner
or dirty:
• The transfer roller may be dirty. See
Chapter XX, "Maintaining Your Printer."
• Run a Fuser Cleaning page from the
Operator Panel. See Chapter XX, "-------
-------."
• If the problem persists, call a service
representative to check the printer.
Corrugated Paper If the page is corrugated:
• Check the paper type and quality.
• Make sure you are using only new
undamaged paper.
• Check for contamination along the paper
path.
• Make sure the paper is not damp.
• Make sure the paper is properly loaded.
• Open the Face-Up Output Tray and print
to this tray.
• Turn over the stack of paper in the paper
tray.
Solution Problem
Damaged Print If the page is torn:
• Check the paper type and quality.
• Make sure you are using only new
undamaged paper.
• Check for contamination along the paper
path.
• Make sure the paper is not damp.
• Make sure the paper is properly loaded.
• Open the Face-Up Output Tray and print
to this tray.
• Turn over the stack of paper in the paper
tray.
Wrinkled Paper If the page is wrinkled:
• Check the paper type and quality.
• Make sure you are using only new
undamaged paper.
• Check for contamination along the paper
path.
• Make sure the paper is not damp.
• Make sure the paper is properly loaded.
• Open the Face-Up Output Tray and print
to this tray.
• Turn over the stack of paper in the paper
tray.
Curl or Wave If the print and the paper have waves or curls:
• Check the paper type and quality. Both
high temperature and humidity will
cause paper curl.
• Turn over the stack of paper in the paper
tray. Also try rotating the paper 180 º in
the paper tray.
• Open the Face-up Output Tray and try
printing to this tray.
Solution
Print Quality Problems 81