Error Messages; Operator Panel Error Messages - NEC SuperScript 1400 User Manual

If the text is garbled or incomplete
Possible Cause
Your computer's If printing from Windows 95/98, exit to a DOS
operating system is prompt and verify functionality with the
malfunctioning. following command:
• At a C:\ prompt, type Dir LPT1, then press
Enter. (This assumes you are connected
to LPT1.)
• Exit Windows and reboot the computer.
• Turn the printer off and then back on
again.
Pages print, but are totally blank
Possible Cause
The Toner Cartridge is Replace with a new NEC SuperScript 1400
defective or out of toner. Series Toner Cartridge.
The sealing tape may • Remove the Toner Cartridge and pull out
still be in the Toner the sealing tape.
Cartridge.
• Reinstall the Toner Cartridge, and check
the printer by printing a Configuration
Sheet.
The file may have blank Check the file to make sure that it does not
pages. contain blank pages.
Some parts, such as the Contact a service representative.
Controller Board, may
be defective.
Solution
Solution
E M
RROR ESSAGES

Operator Panel Error Messages

When the printer experiences an error, the Operator Panel
will indicate the error messages by the LEDs. Find the light
pattern below that matches the printer light pattern and
follow the solutions to clear the error.
Light Status Legend
Light off
Light On
Light blinking
Mode
Power Off
If all of the Operator Panel LEDs are not lit:
• Make sure the power cord is plugged in.
• Make sure the power switch is turned on.
• Make sure the printer is powered with the specified
AC voltage.
Paper Out
If the amber Paper LED is blinking:
• The paper tray is empty and must be refilled with
paper. The Paper LED blinks until paper is added.
• Loading paper into the tray will clear this message
and allow you to continue printing.
Message

Error Messages

67