NEC SuperScript 1450 User Manual page 78

Mode
Paper Out Manual Feed Tray
• The Multipurpose Tray (Tray 1) is empty and must
be refilled with paper.
• Load the correct paper into the tray and press the
Go/Continue button to print each page.
Paper Jam
There is a paper jam somewhere in the printer. Clearing
the paper jam will cancel this message.
Paper Size Error
The engine detected a paper size mismatch between the
paper loaded in one of the paper trays and the size
specified in an application.
Memory Overflow Error
The document is too complex, and printer does not have
enough memory to print the job.
• Try to free some printer memory by removing any
unnecessary fonts, macros, or any data currently in
printer memory.
• Add more printer memory. See Chapter XX, "-------."
• For a temporary solution, simplify the image or print
at a lower resolution.
78 Chapter 9, Troubleshooting
Message Mode
Cover Open/No Toner Cartridge
The printer has the cover open, or no toner cartridge.
• Check that the printer Top Cover and Face-up
Output Cover are closed properly.
• Make sure that the toner cartridge is correctly
installed in the printer.
Internal Error
The printer detects an internal error.
All four LEDs blink sequentially and fast.
• Reset the printer by briefly turning the printer off
and back on again.
• If the error persists, contact the service
representative.
Engine Error
The printer detects an engine error (LSU or Fuser).
All four LEDs blink at the same time.
• Reset the printer by briefly turning the printer off
and back on again.
• If the error persists, contact the service
representative.
Message