Connecting A Ups To The Express5800/320Ma System - NEC Express5800/320Ma Software Installation And Configuration Manual

Connecting a UPS to the Express5800/320Ma System

An APC Network Management Card EX (APC part number AP9617) on these UPS
models and PowerChute Network Shutdown (PCNS) on the Express5800/320Ma
system enable the system and the UPS to communicate over your network.
Checklist: Setting Up a UPS and Installing PCNS on Express5800/320Ma
Systems
Connect the UPS to the Express5800/320Ma system, as described in
a UPS to the Express5800/320Ma System" on page
Configure the UPS, as described in
Install PCNS on the Express5800/320Ma system, as described in
on the Express5800/320Ma System" on page
Configure the PCNS user interface, as described in
Interface" on page
Verify the installation, as described in
page A-7.

Connecting a UPS to the Express5800/320Ma System

1. On the Express5800/320Ma system, verify that the operating system is shut down,
and then power down the system.
2. Plug the UPS input power cord into an AC receptacle connected to utility power.
3. Connect an Ethernet cable to the UPS Ethernet port.
4. Turn on the UPS by pressing the ON switch.
5. Connect the A-side power cords from one or more Express5800/320Ma systems
directly to the UPS, or connect the A-side power distribution unit (PDU) to the UPS.
A-2 Express5800/320Ma: Software Installation and Configuration Guide
A-6.
N O T E S
1. APC Smart-UPS
Express5800/320Ma system. APC Symmetra
models support multiple Express5800/320Ma
systems.
2. For information about connecting systems or PDUs to
the UPS, see the Express5800/320Ma: Installation
Guide.
"Configuring the UPS" on page
A-5.
"Verifying the PCNS Installation" on
®
models support a single
"Connecting
A-2.
A-3.
"Installing PCNS
"Configuring the PCNS User
®