Configuring The Ups - NEC Express5800/320Ma Software Installation And Configuration Manual

Configuring the UPS

1. Turn on power to the Express5800/320Ma system, and log on to the Windows
Administrator account.
2. Verify that the UPS and its management card have been assigned an IP address,
and that an Ethernet cable is connected to the UPS and to your LAN. For more
information, see the Network Management Card Installation and Quick Start
Manual from APC.
3. In a Web browser, enter http:// and the IP address of the UPS (for example,
xxx.xxx.xxx
http://
If Internet Explorer is configured with its default security settings, a message box
with the following message is displayed the first time you attempt to configure your
UPS with PowerChute software:
Content from the Web site listed below is being blocked by
the Internet Explorer Enhanced Security Configuration.
http://xxx.xxx.xxx.xxx
.
.
.
If you trust this Web site, you can lower security settings
for the site by adding it to the Trusted sites zone....
In this message, xxx.xxx.xxx.xxx is the IP address of either the PCNS user
interface Web page or the UPS management card Web page. Click Accept to add
this address to Trusted Sites. Make sure that Active scripting for Trusted Sites is
set to either Enable (the default) or Prompt. If Active scripting is set to Prompt,
allow scripting when prompted. If you close the message box without adding the IP
address to Trusted Sites, you will be unable to configure the UPS.
4. If prompted for a password, supply a valid password for the UPS.
5. In the left column of the Network Management Card page, click the name of the
UPS.
6. In the left column, click Configuration.
7. On the Configuration page, use the settings in
parameters. Click Apply after you modify the settings.
).
Connecting a UPS to an Express5800/320Ma System

Configuring the UPS

Table A-1 for the shutdown
A-3