Vmware Restore Options - HP Data Protector A.06.11 Integration Manual

7. In the Start Restore Session dialog box, click Next.
8. Specify Report level and Network load.
Click Finish to start the restore.
The message Session completed successfully is displayed at the end
of a successful session.
Table 1 1 VMware restore options
GUI/CLI option
Restore client/
-destination
86 Integrating VMware Virtual Infrastructure and Data Protector
Description
Specifies the client that the restore session is started on.
By default, the session is started on the same client on
which the backup was started.
Change the default only in the case of a disaster recovery
when you restore from a Suspend, Snapshot, or
VCBimage backup and the new VMware management
client does not have the same name as the original one.
Ensure that the new client has access to all the required
datastores.
You can also change the default if you want to restore
the virtual machines outside of a datacenter, in which
case you must specify the client to restore to.
If you select a client that has not been configured for use
with the Data Protector VMware Virtual Infrastructure
integration, a warning is displayed. Click OK and
configure the client as described in
management clients" on page 39. However, to restore
outside of a datacenter, you do not need to configure the
destination client, just click Cancel.
To change the configuration of the selected client, click
the Connection button.
"Configuring VMware