Reset Bmc Passwords; Configure Serial Port Parameters - HP Integrity rx1620 Operation Manual

Table 3-7 Management Processor Commands and Descriptions (continued)
Command
PS
RB
RS
SA
SE
SL
SO
SS
SYSREV
TC
TE
UC
VFP
WHO
X
XD

Reset BMC Passwords

BP: Reset BMC Passwords
This command resets BMC passwords (both USER and ADMIN passwords).

Configure Serial Port Parameters

CA: Configure local and remote serial port parameters
Set up the local serial port parameters as follows:
• TERMINAL TYPE: Vt100 vs HPterm
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400,
115200 bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
• TRANSMIT CONFIGURATION STRINGS: Disable this setting whenever the modem being
used is not compatible with the supported modem (MT5634ZBA).
IMPORTANT:
Set up the remote serial port parameters as follows:
• MODEM PROTOCOL: Bell or CCITT (CCITT is a European standard; RTS/CTS signaling
is used, as well as the Ring signal. Bell is a U.S. or simple mode).
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400,
115200 bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
Description
Power management module status
Reset BMC
Reset system through RST signal
Set access
Enter OS session (UNIX only)
Show event logs
Security options
System processor status
Current system firmware revisions
Reset via transfer of control (TOC)
Tell- send a message to other users
User configuration
Virtual front panel
Display connected management processor users
Exit management processor and disconnect
Diagnostics and/or reset of management processor
Do not mix HP and vt100 terminal types at the same time.
Management Processor Command Interface 63