Transfer Of Control; Tell; User Configuration - HP Integrity rx1620 Operation Manual

NOTE: At the time of production of this guide, the firmware revisions were:
FIRMWARE INFORMATION
Firmware Revision: 1.10 [4341]
PAL_A Revision: 7.31/5.37
PAL_B Revision: 5.37
SAL Spec Revision: 3.01
SAL_A Revision: 2.00
SAL_B Revision: 1.10
EFI Spec Revision: 1.10
EFI Intel Drop Revision: 14.61
EFI Build Revision: 1.10
POSSE Revision: 0.10
ACPI Revision: 7.00
BMC Revision: 2.24
IPMI Revision: 1.00
SMBIOS Revision: 2.3.2a
Management Processor Revision: E.02.25

Transfer Of Control

TC: System reset through INIT or TOC (Transfer of Control) signal
Under normal operation, shut down the OS before issuing this command.
This command causes the system to be reset through the INIT (or TOC) signal. Execution of this
command irrecoverably halts all system processing and I/O activity and restarts the computer
system. It is different from the RS command in that the processors are signaled to dump state
on the way down.

Tell

TE: TEll—sends a message to other terminals
Up to 80 characters can be typed in. The message is broadcast to the other mirrored clients. Users
in a session or CSP are not shown the message.

User Configuration

UC: User Configuration—controls user access
70 Utilities