Events Without Sensors - HP Integrity rx1620 Operation Manual

Table A-5 IPMI Origins (continued)
Number
0x07
0x08
0x09
0x0F
0x10
0x11
0x1F
For example:
Data2 Data3
80 03 ipmi req from the CLI thd for CHASSIS_CONTROL_POWER_DOWN ( p 0")
81 03 ipmi req from the CLI thd for CHASSIS_CONTROL_POWER_UP ( p 1")
80 01 ipmi req from via BT for CHASSIS_CONTROL_POWER_DOWN
83 03 ipmi/RS req from the CLI thd for CHASSIS_CONTROL_HARD_RESET
00 FA CHASSIS_CONTROL_POWER_DOWN req from the ACPI sensor (S5)
00 D9 CHASSIS_CONTROL_POWER_DOWN req from CPU0 temp sensor
01 0E CHASSIS_CONTROL_POWER_UP req from WakeOnLan sensor

Events Without Sensors

The BMC logs these events with a "sensor number" of 0; there is no matching SDR entry.
Table A-6 Events Without Sensors
Triplet Event
10:70:64 SEL almost full
12:70:64 BMC entering firmware update
mode
12:70:05 SFW flash Inlock
12:70:06 Front panel lock
12:F0:06 Front panel unlock
12:70:64 Firmware update application:
starting component update
12:70:64 Firmware update application:
ending component update
12:70:80 BMC entering special mode
12:70:A1 BMC firmware initializing
1D:70:00 BMC Cold Reset
108 Event, Error, and Warning Messages
Source
intelligent platform management bus (IPMB)
inter IC (I2C)1
I2C2
keyboard controller style (KCS)0
KCS1
KCS2
System Power Thread (Used by Power Restore Policy)
data 2 data 3
1F %full
Mode –
Major FW rev. Minor FW rev.
Notes
The BMC logs this when the
SEL is 75% full
Mode is a bit-map:Bit 0:
ShmooBit 1: MfgTestBit 2:
Shutdown overrideBit 3: Fixed
fan speedBit 4: MfgBits 7-5:
unused, set to 0