HP Integrity rx1620 Operation Manual page 102

Table A-1 EFI Error and Warning Messages (continued)
Error Error/Warning Message
Number
23 Error reading BMC first boot token
24 Primary FIT failed
25 Secondary FIT failed
26 Processor Abstraction Layer (PAL)_A warning. One
copy of PAL is bad
27 PAL_B warning. Not compatible with at least one
CPU
28 Memory errors detected and page de-allocation table
(PDT) is disabled
30 Memory required reinterleave to get a good page 0
31 One or more ranks have chipspare disabled
33 One or more memory ranks are mismatched and
deallocated
34 Memory deallocated because of a loading error
35 Memory is not loaded in recommended loading order
36 The page deallocation table (PDT) is full
37 At least one (1) CPU has bad fixed core ratio
38 All CPUs were slated for compatibility deconfig
39 Incompatible CPUs detected
40 CPUs installed with mixed cache sizes
41 CPUs installed with mixed steppings
42 All CPUs are over clocked
43 At least one (1) CPU is over clocked
44 Monarch changed to lowest stepping CPU
46 CPUs loaded in wrong order
48 System Abstraction Layer (SAL) NVM cleared
102 Event, Error, and Warning Messages
Solution
Communication with the BMC failed. Replace
the base unit.
Reflash firmware
Reflash firmware
Reflash firmware
Update firmware
Reseat DIMMs, if error persists replace bad
DIMMs
Information only, no action required.
Information only, no action required.
Check memory installation. Match DIMM part
numbers within each quad.
Check memory installation. DIMMs must be
installed with smallest capacity in the first quad,
an equal or larger capacity in the second quad,
and an equal or largest capacity in the third
quad.
Check memory installation. DIMMs must be
installed with smallest capacity in the first quad,
an equal or larger capacity in the second quad,
and an equal or largest capacity in the third
quad.
Clear with pdt clearcommand in EFI shell
Check processor installation. (Verify installation
and that identical processors have been
installed.)
Processor failure. Verify installation, then
replace processor. Contact the HP Support center
for assistance.
Check processor installation and match CPU
part numbers. CPUs must be identical.
Check processor installation and match CPU
part numbers. CPUs must be identical.
Check processor installation and match CPU
part numbers. CPUs must be identical.
Check processor installation and match CPU
part numbers. CPUs must be identical.
Check processor installation and match CPU
part numbers. CPUs must be identical.
Information only. If the message is repeated,
contact the HP Support center for assistance.
Reload processors in correct order.
Information only, no action required