HP Integrity rx1620 Operation Manual page 52

comparing the values shown for PCI Bus, PCI Device, and PCI Function to the Bus #,
Dev #, and Fnc # values from the info io command.
CAUTION:
screen:
•
Auto Termination
•
SCSI Parity
•
SCSI Bus Scan Order
•
Spinup Delay (Secs)
Changing any of these fields can cause unpredictable results.
CAUTION:
•
Scan Id
•
Scan LUNs > 0
•
Disconnect
•
SCSI Timeout
•
Queue Tags
•
Format
•
Verify
Changing any of these fields can cause unpredictable results.
7. You may display (and optionally change) any SCSI parameters listed below for the channel
of the SCSI interface, or restore its SCSI parameters to their default values.
• SCSI ID
• Maximum data transfer rate
• Bus width
• Whether the SCSI interface is bootable (driver support)
• Avoid bus resets (secondary cluster server)
• Restore Defaults
8. Use the arrow keys to navigate to the appropriate SCSI parameter.
9. Use the plus (+) and minus (-) keys to scroll through the values until the value you want is
displayed.
10. Press Esc to exit the "Adapter Properties" screen. You are given these choices:
• Cancel the exit from the screen (to stay in the "Adapter Properties" screen for the channel
of the SCSI interface)
• Save the changes you made and then exit the screen
• Discard the changes you made and then exit the screen
11. Move the cursor to the action (cancel, save, or discard) you want to take; press Enter.
If you selected cancel, you remain in the "Adapter Properties" screen for the channel of the
SCSI interface. You can still change the channel's parameters listed above.
If you selected save or discard, you are placed in the EFI SCSI Setup Utility's main menu.
CAUTION:
12. Press Esc to exit the main menu and the EFI SCSI Setup Utility.
13. Select the option for exiting the utility.
14. When you are prompted to, press Enter to stop the SCSI interface; you are now back at the
EFI shell prompt.
52 Utilities
Do not change the value for any of these fields on the "Adapter Properties"
Do not change the value for any of these fields on the "Device Properties" screen:
Do not select the <Global Properties> option on the main menu.