Reset Bmc Passwords; Configure Serial Port Parameters - HP Integrity rx1620 Operation Manual

Table 4-7 Management Processor Commands and Descriptions (Continued)
Command
PR Power restore
PS Power management module status
RB Reset BMC
RS Reset system through RST signal
SA Set access
SE Enter OS session (UNIX only)
SL Show event logs
SO Security options
SS System processor status
SYSREV Current system firmware revisions
TC Reset via transfer of control (TOC)
TE Tell- send a message to other users
UC User configuration
VFP Virtual front panel
WHO Display connected management processor users
X Exit management processor and disconnect
XD Diagnostics and/or reset of management processor

Reset BMC Passwords

BP: Reset BMC Passwords
This command resets BMC passwords (both USER and ADMIN passwords).

Configure Serial Port Parameters

CA: Configure local and remote serial port parameters
Set up the local serial port parameters as follows:
• TERMINAL TYPE: Vt100 vs HPterm
• BAUD RATES: Input and output data rates are the same; 300, 1200, 2400, 4800, 9600, 38400, 115200
bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; Software uses Xon/Xoff.
• TRANSMIT CONFIGURATION STRINGS: Disable this setting whenever the modem being used is not
compatible with the supported modem (MT5634ZBA).
Chapter 4
Description
Management Processor Command Interface
Utilities
65