Fujitsu Eternus DX80 S2 User Manual page 70

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
■ For regions other than EMEA&I
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the
rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance
between the front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the
rack rail must be attached to the rack before they can be completely tightened.
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
[Left] (for left side).
(Front rack pillars)
[Right]
(2)
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the four washers
to fasten the rack rails to the rear rack pillars.
Make sure to attach the rack rails and rack pillars so that they fit
exactly together without any space between them.
Rack rail (for left side)
Plate
M5 screws
(Front rack pillars)
M5 screws
Copyright 2012 FUJITSU LIMITED
(Rear rack pillars)
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
M5 screws
Washers
(Rear rack pillars)
Plate
Rack rail (for right side)
70
M5 screws
Washers
P3AM-4842-03ENZ0