Fujitsu Eternus DX80 S2 User Manual page 63

Chapter 5 Installing Optional Products
5.1 Installing Drives
7
8
■
For 3.5" drives
Procedure
1
2
3
4
4-1
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
In the [Disks] screen of [Component] on the ETERNUS Web GUI screen, check
that the added drives have been recognized.
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
drives, as required.
In the [Storage] screen of [Component] on the ETERNUS Web GUI screen,
check that all components of the ETERNUS DX Disk storage system are in
normal status.
Wear a wrist strap or touch a metal part to discharge the human body's natural
static electricity.
Remove the dummy drive unit from the slot in which the drive is to be installed.
Push into the tab of the dummy drive unit and pull it straight out of the drive slot.
The removed dummy drive unit should be retained for future use.
IMPORTANT
Install the new drive.
Press the catch on the drive lock lever to unlock it.
Catch
Lock lever
Copyright 2012 FUJITSU LIMITED
Dummy drive unit
Tab
63
End of procedure
P3AM-4842-03ENZ0