Fujitsu Eternus DX80 S2 User Manual page 69

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
(2)
Insert the pins of the left slide rail in the 1st and 3rd holes from the bottom of the 2U
rack rail.
(3)
Secure the left slide rail to the front pillar using the M5 centering screw and M5 pan
head screws.
(4)
For the right slide rail, insert the pins in the holes of the rear pillar, and secure the other
side of the slide rail to the front pillar in the same way as the left slide rail.
(5)
Push the M5 cage nuts into the 2nd holes of the front rack pillars above the base line of
the drive enclosure.
The M5 centering screw and M5 pan head screw positions for the slide rails and 2U
rack rail are determined relatively to the base line of the drive enclosure.
Tighten the screws referring to the following figure.
[Left]
3rd position
(M5 centering screw)
2nd position
2U
(M5 cage nut)
1st position
(M5 pan head screw)
Copyright 2012 FUJITSU LIMITED
[Right]
Drive enclosure
(M5 pan head screw)
Base line of
drive enclosure
Rack rails
69
M5 Centering screw (10mm)
M5 Cage nut
M5 Pan head screw (10mm)
3rd position
(M5 centering screw)
2nd position
(M5 cage nut)
1st position
P3AM-4842-03ENZ0