Fujitsu Eternus DX80 S2 User Manual page 118

Appendix A Event Notification Message List
A.2 Message List
Event type
M 21810xxx
M A0110xxx
M A0410xxx
M A0810xxx
M A0A10xxx
M A0B10xxx
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
SNMP Trap
Trap
Trap
code
Maintenance
No.
Info
7 21810xxx
7 A0110xxx
7 A0410xxx
7 A0810xxx
7 A0A10xxx
7 A0B10xxx
Copyright 2012 FUJITSU LIMITED
Upper: Message
Lower: Description
RAID Group#0xxx recovered end of Rebuild processing
Rebuild to the hot spare or the replaced drive is complete,
but Bad Data (data lost identifier) exists.
xxx: RAID group number (hexadecimal)
RAID Group#0xxx start failure of Rebuild processing
Rebuild to the hot spare has not started.
xxx: RAID group number
RAID Group#0xxx start procedure of Rebuild processing
Rebuild to the hot spare has started.
xxx: RAID group number (hexadecimal)
RAID Group#0xxx normal end of Rebuild processing
Rebuild to the hot spare is complete.
xxx: RAID group number (hexadecimal)
RAID Group#0xxx abnormal end of Rebuild processing
because of source disk problem
Rebuild to the hot spare is halted because an error is
found in the copy source drive.
xxx: RAID group number (hexadecimal)
RAID Group#0xxx abnormal end of Rebuild processing
Rebuild to the hot spare is halted.
xxx: RAID group number (hexadecimal)
118
Remarks
These mes-
sages are noti-
fied when
"Complete
rebuild" is
enabled for Error
Severity Level in
the event notifi-
cation setting.
They are not noti-
fied during main-
tenance
operations.
These mes-
sages are noti-
fied when
"Rebuild/
Copyback w/o
redundant" is
enabled for Error
Severity Level in
the event notifi-
cation setting.
They are not noti-
fied during main-
tenance
operations.
These mes-
sages are noti-
fied when
"Rebuild/
Copyback w/
redundant" is
enabled for Error
Severity Level in
the event notifi-
cation setting.
They are not noti-
fied during main-
tenance
operations.
These mes-
sages are noti-
fied when
"Rebuild/
Copyback w/o
redundant" is
enabled for Error
Severity Level in
the event notifi-
cation setting.
They are not noti-
fied during main-
tenance
operations.
P3AM-4842-03ENZ0