Table of Contents
Advertisement
SET YOUR TELEVISION
TO THE VCR CHANNEL
1. Set your TV to Channel 3 unless Channel 3 is
one of the TV stations in your area. If Channel 3
is used in your area, set your "IV to Channel 4.
The RF Channel Select Switch is located on the
Rear Control Panel. Slide the switch of CH3 or
CH4 to match the channel selector on your TV.
This is the VCR channel on your television
set.
Your television
receiver
must be tuned to this
channel any time a video cassette is played back
on the VCR.
"%=
o
i
¢-e-e
_
F=llDooooooooo
_
_
_
lllllOIIOIIIOIl[ II_
o
"
-
I@,=._£1IlllOIllllllaDlr
I
I _
.ul_i.......ll$1nlflflllllflfllfllIll',!,
il u_'_ I _-----
]"RF Channel" Select Switch
NOTES:
• If the range is short, try new batteries.
• An object between the VCR and remote control
may block the invisible light beam and operation
will not be possible.
"CHANNEL"
Select Button (vor^)
E._CT
, "
"',
o
o
(D ® ®
@19@
® 0
i=;-J
2. Plug the VCR power cord into a 120V electrical
outlet and press "POWER"
ON/OFF button on,
and the "POWER" and "
_
" lights will come
on. The clock will show .....
(See "Clock Setting" Instructions on page 26.)
NOTE:
When
the
power
is turned
on, the
"VCR/'FV" selector is switched to the VCR mode
automatically.
"POWER" ON/OFF Button
3. Select an active TV channel
by pressing
the
Channel Select button (/_ orv)
on the remote
control aiming at the front panel of the VCR. The
picture from that channel
should
now be dis-
played on your television.
4. Fine tune the television for best picture.
NOTE: If both Channel 3 and Channel 4 are in
use in your area, select the one which does not
interfere with the playback picture.
SPECIAL NOTE:
Certain
television
receivers
with "ELECTRONIC
TUNERS" may require special procedures to tune
Channel 3 or 4. These receivers may not tune to the
VCR channel (3 or 4) because there isn't an active
"IV station on these channels.
In these cases, press VCR "POWER"
ON/OFF
button on. Make sure that the " _
" indication in
the display is on. If the indication is off, press
"VCR/'I-V" selector on the remote control to turn the
" _
" indication on. Tune VCR tuner to an active
channel. The television receiver will now tune in to
the VCR channel
(Channel
3 or 4). For more
detailed
instructions,
consult your TV owners
manual.
HOW TO INSTALL THE BATTERIES
IN THE
REMOTE CONTROL
NOTES:
1. Be sure to install two
"AAA"
size batteries
(not supplied)
before
use.
2. Be aware of the polarity.
(Remove
the protect
compartment
cover
completely.)
-15-
Advertisement
Table of Contents
