Sears LXI series 580.53484390 Owner's Manual page 43

VCR Plush'+ PROGRAMMING
IMPORTANT: Before you try to record with VCR
Plus+ for the first time, be sure you have completed
any map described on the previous pages.
Programming with VCR Plus+
_i) Turn on the -IV and VCR. Turn the "IV to the
"VCR Channel" (3, 4 or video input) so you can
see the program menu on the "IV screen. Make
sure the VCR's clock is set to the correct time
and date as described on page 26.
_) Press the VCR Plus+ button on the remote
control to display the VCR PLUS PROGRAM
menu.
NOTE: If all timer programs are full, FULLY
PROGRAMMED will appear on the "IV screen.
First press
VCR Plus+
VCR PLUS PROGRAM
PUSH VCR PLUS CODE:
\1/
/1\
TO ENTER PUSH DISPLAY
TO END PUSH VCR PLUS
@
O
Enter the Plus Code from the TV Guide,
newspaper, etc. for the program you want to
record.
NOTE: If you enter an incorrect number,
repeatedly press the CLEAR button on the
remote control to erase it, and then enter the
correct number.
After entering the Plus Code, press the
DISPLAY button to enter your program into
memory.
NOTE: If you enter a code number that your
VCR does not recognize, it will display this
message on the "IV screen: PLEASE CHECK
NUMBER. If this message appears, check the
number and enter it again.
If a valid number has been entered the following
display will appear.
VCR PLUS PROGRAM
PUSH SELECTION NUMBER
/
1 NORMAL PROGRAM
2 DAILY PROGRAM (M-F)
3 WEEKLY PROGRAM
TO END PUSH VCR PLUS
.t One time program
Same program
m Monday through
Friday
Same program
once a week
O Press number button "1", "2" or "3" to choose
which type of program you want to record. The
VCR will then display the record speed
information on the TV screen.
VCR PLUS PROGRAM
PUSH SELECTION NUMBER
RECORD SPEED:
\111 IIII II II I II/
SP=I LP=2 EP=3
AUTO=4
/111t1111111111 \
TO END PUSH VCR PLUS
Tape
recording
speed
If you want to change the tape speed, press the
1, 2, 3 or 4 button on the remote control. The
VCR will then display the program review mode
on the TV screen for confirmation. If you want to
erase the program, press the CLEAR button on
the remote control.
NORMAL PROGRAM
PROGRAM 1
CA 33 SPEED SP
START TIME 01:00 AM
STOP TIME 02:30 AM
START DATE 07/07/93
WED
TO ERASE PUSH CLEAR
TO END PUSH VCR PLUS
@
O
Press the VCR Plus+ button when you are
finished.
Turn off the VCR before the recording is to begin.
IMPORTANT: If you are recording a channel
which requires use of a cable box, remember to
tune the cable box to the desired channel and
leave the cable box turned on some time before
the recording is scheduled to start.
- 42 -