Antenna/Vcr Connections - Sears LXI series 580.53484390 Owner's Manual

ANTENNANCR CONNECTIONS
ANTENNAS WITH ONE LEAD (Combined VHF-UHF)
I
300-ohm Twin-lead Flat Cable
VCR
i_,. _,. ® _ _____JD0000DU000 00______lf_
0 "_ "_ ouch, 0 I_o_._ ,.r_._ O000DOOODODUO OlO O0_ o
• __J_l II _
To "IN FROM ANT"
75-ohm Coaxial (round) Cable
1. Disconnect the antenna leads from the rear of the
"IV receiver.
2. Identify the type of cable from your antenna. If it is
a round cable as illustrated, it is a 75-ohm coaxial
antenna cable. This cable will connect directly to
the connector marked "IN FROM ANT" on your
VCR.
If your antenna lead wire is a flat type antenna
cable, connect it to the Antenna Adaptor (300-ohm
to 75-ohm) (not supplied) and slip the Adaptor onto
the "IN FROM ANT" terminal. The Adaptor does not
screw onto the VCR, it just slips over the connector.
ANTENNA WITH SEPARATE VHF-UHF LEADS
VHF Antenna UHF Antenna
"T o
ohm Twin-le
i
I '
R-AUOIO-L VlDEO
I Flat Cable
VCR
flDDDDDfl.qOII]DI] Dfl_B_
_,_._._J ODDDflflfll]OI]D DD,L_I]fl
I_llfll]flllflrl.flfl[lflflfll]nl] m_._-_ =
To "IN FROM ANT"
Antenna Mixer (VHF/UHF 300-ohm to
75-ohm) (not supplied)
1. Disconnect the UHF/VHF twin leads on your
television.
2. Locate Antenna Mixer(VHF/UHF 300-ohm to 75-
ohm) (not supplied).
3. Connect the VHF Twin-lead Cable to the "VHF"
terminals on the Antenna Mixer.
-6-
4. Connect the UHF Twin-lead Cable to the "UHF"
terminals on the Antenna Mixer.
5. Slip the Antenna Mixer onto the "IN FROM ANT"
terminal.