Table of Contents
Advertisement
VCR Plus
TM
-F CHANNEL
MAPPING
FOR CONNECTION
A
Use these Channel Mapping instructions
only if
you have your VCR connected
as shown
in
Connection A on the previous page.
Only channels that are assigned a VCR Plus+ guide
number
different
than the number
you select to
watch that channel on your IV require map. A chart
of the assigned VCR Plus+ guide numbers is usually
published
in your local TV listings
or TV Guide.
Check the list of VCR Plus+ guide numbers for your
area to see if any of the assigned
numbers
are
different than the channel number you select on your
TV.
Home Antenna
Map : If you have connected
a
home antenna to your VCR, most channels probably
do not require any map. If the published VCR Plus+
guide numbers
are all the same as the channel
number you select when you watch that station, no
map is necessary. You can skip the map information
on these two pages.
TO MAP CHANNELS
_]_ Make sure that you have selected the correct -FV
system (I-V or CATV).
_)
Display the CHANNEL MAPPING screen.
Press the VCR Plus+ button twice on the remote
control.
First press
VCR Plus+.
VCR PLUS
PROGRAM
MENU will
appear.
VCR PLUS PROGRAM
PUSH VCR PLUS CODE:
TO ENTER PUSH DISPLAY
TO END PUSH VCR PLUS
Cable-TV Map : If you have connected
a cable-TV
system to your VCR, you will map any channel that
has a VCR Plus+ guide number different than the
number you select to watch that channel on your "IV.
Then press VCR
Plus+ again
(without VCR PLUS
code).
VCR PLUS
MAIN MENU
will appear.
VCR PLUS PROGRAM
PUSH SELECTION NUMBER
1 VCR PLUS PROGRAM
2 PROGRAM REVIEW
P" 3 CHANNEL MAPPING
TO END PUSH VCR PLUS
BEFORE
MAPPING
CHANNELS
e You can map channels from only one "IV system
(TV or CATV) at a time.
Make sure that you have selected the correct TV
system.
• On a piece of paper, write down which channels in
your TV listings correspond to the channels you
receive.
• Turn on the power of both VCR and TV.
• Be sure that the TV is set to the VCR output
channel (3 or 4).
Aim the remote control at the receiver on the front
of the VCR.
_) Press 3 to begin channel Mapping process. The
following will appear on the TV screen.
This screen appears only if the TV system (TV or
CATV) is set to CATV.
CHANNELSOURCESELECT
= 1VCR CHANNEL
2CABLE
BOX CHANNEL
3CABLE BOX WITH
_B SELECTOR
TO END PUSH VCR PLUS
_]) Press 1 for VCR CHANNEL Mapping.
- 37 -
Advertisement
Table of Contents
