Set Your Television To The Vcr Channel - Sears LXI series 580.55154490 Owner's Manual

SET YOUR TELEVISION TO THE VCR CHANNEL
1. Set your TV to Channel 3 unless Channel 3 is
one of the TV stations in your area. If Channel 3
is used in your area, set your TV to Channel 4.
The RF Channel Select Switch is located on the
Rear Control Panel. Slide the switch of CH3 or
CH4 to match the channel selector on your TV.
This is the VCR channel on your television set.
Your television receiver must be tuned to this
channel any time a video cassette is played back
on the VCR.
NOTES:
1. An object between the VCR and remote control
may block the invisible light beam and operation
will not be possible.
2. Try new batteries.
_ i_i_i _ii _iiiiii_i_! _i_i _'i_i! _iii?_ili_ _!_!_ i ji _ _,_ i,i_i_i _iii_i_Di_,,ii!_! _ i_;_i_i:ii_,_i:_i_ii_,%:i_iii_i_i_i_ii_i_i!i_i!_i_!_! i_i_i_ii!i_iiii!_i,!iii_i!_ _i_!_i_i_i!_; ii I
iii iiiiiiiiil iiiiiiil iiiiiiiiiiiiii iiiiiiii!iii iii i
"RF _hannei;i Seie¢_ itch
2. Plug the VCR power cord into a 120V electrical
outlet and press "POWER" ON/OFF button on,
and the "POWER" and " [_ " lights will come
on. The clock will show .....
(See "Clock Setting" Instructions on page 28.)
NOTE: When the power is turned on, the
"VCR/TV" selector is switched to the VCR mode
automatically.
4. Fine tune the television for best picture.
NOTE: If both Channel 3 and Channel 4 are in
use in your area, select the one which does not
interfere with the playback picture.
SPECIAL NOTE:
Certain television receivers with "ELECTRONIC
TUNERS" may require special procedures to tune
Channel 3 or 4. These receivers may not tune to the
VCR channel (3 or 4) because there isn't an active
-IV station on these channels.
In these cases, press VCR "POWER" ON/OFF
button on. Make sure that the " _ " indication in
the display is on. If the indication is off, press
"VCR/'I-V" selector on the remote control to turn the
" _" indication on. Tune VCR tuner to an active
channel. The television receiver will now tune in to
the VCR channel (Channel 3 or 4). For more
detailed instructions, consult your TV owners
manual.
3. Select an active TV channel by pressing the
Channel Select button ( • or V) on the VCR or
remote control by aiming it at the front panel of
the VCR. The picture from that channel should
now be displayed on your television.
REMOTE CONTROL
- 20 -