Assembling The Projection System; Attaching The Spacer Legs To The Top Projection Unit - Runco 3Dimension D-113d Installation & Operation Manual

Installation
3.5
Assembling the
Projection System
Attaching the Spacer Legs
to the Top Projection Unit
DO NOT OVER-TIGHTEN THE SCREWS.
Caution
4. Place the bottom projection unit (the one with pockets and tapped holes in place of
the cosmetic caps on the top) upside down on a smooth, flat surface covered with a
blanket or other soft material. Loosen and remove the two front feet on the projection
unit.
5. Repeat Step 3 for the bottom projection unit.
The top and bottom projection units must be secured to each other using the four (4),
supplied spacer legs and associated hardware.
Using a hex wrench and eight (8) of the supplied, M6 x 16mm socket-head cap screws,
attach the spacer legs to the top projection unit as shown in Figure 3-7.
Figure 3-7. Attaching the Spacer Legs to the Top Projection Unit
30 D-113d Projection System Installation/Operation Manual
1
Screw, M6 x 16mm
Socket-Head Cap
(8x)
2
Spacer Leg (4x)