3D Processing - Runco 3Dimension D-113d Installation & Operation Manual

Operation

3D Processing

3D Processing
3D Mode
Reverse Eyes
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Lamp Settings
• Color temperature and white balance
To select a memory preset, press
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
To save the settings for the current input and display mode to the
Note
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 83).
To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press or to highlight Reset and press ENTER.
Select 3D Processing from the Main Menu to set the following options related to
formatting and delivery of HDMI 3D content.
3D Mode: Select 3D Mode from the 3D Processing menu to specify how the Primary and
Secondary DHD Controllers process the "left eye" and "right eye" image components
respectively.
• Choose Auto to have the DHD Controller determine the appropriate 3D mode based
on the HDMI vendor-specific InfoFrame data. This is the default setting.
• Choose Off for 2D content.
• Choose Side-by-Side to have the Primary
and Secondary DHD Controllers scale the
left and right image halves respectively to fill
the screen.
Side-by-Side multiplexing is used with 1080i
source material.
• Choose Top-and-Bottom to have the
Primary and Secondary DHD Controllers
scale the top and bottom image halves
respectively to fill the screen.
Top-and-Bottom multiplexing is used with
720p or 1080p source material.
or to highlight it and press ENTER.
or to highlight Save and press ENTER.
74 D-113d Projection System Installation/Operation Manual