D-113D Input Panel - Runco 3Dimension D-113d Installation & Operation Manual

1. RIGHT (INTAKE) SIDE PANEL
The right side panel is perforated to allow cool air to enter the projector.
2. LEFT (EXHAUST) SIDE PANEL
The left side panel is perforated to allow warm air to exit the projector. Removing this
panel provides access to the lamps.
3. INPUT PANEL COVER
Removing this panel provides access to the projector input panel. For more
information, refer to D-113d Input Panel on page 9.
4. REAR EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not obstructed in any
way.
5. ADJUSTABLE FEET (4)
Located on the underside of the projector are four adjustable feet. Raise or lower
these feet when positioning the projector to ensure it is level on all sides so the
displayed image will appear rectangular without any keystone.
6. PROJECTION LENS
Figure 2-3 shows the D-113d rear input panel. The top and bottom input panels are
labeled "Primary" and "Secondary" respectively, but are otherwise identical.
1 2
1 1
9 9
GPIO RS232 IN
Figure 2-3. D-113d Input Panel
D-113d Projection System Installation/Operation Manual
3 4 5 6
1 1 1 1 1 1
9 9 9 9
PWR
1 2 1 1
1 - IN 2 - IN 1 - OUT 1 - OUT
7
2
8
9
9
System Overview
2.2

D-113d Input Panel